News
The temperature is getting higher and higher, and the air humidity is high in summer. In a hot and humid environment, it is difficult to avoid the problem of equipment heating after operation. Continuous heating will cause damage to the cutting equipment. Scientific maintenance of the laser cutting machine can not only avoid some minor faults, improve cutting efficiency, but also increase the service life of accessories.
1. The temperature is high in summer, the cooling water of the laser cutting machine must use distilled water or pure water, and the scale should be cleaned regularly, so as not to cause the scale attached to the laser pipe to affect the laser power. Different types of laser cutting machines have different methods of cleaning scale. When cleaning scale, contact the manufacturer in advance for guidance.
2. It is recommended that all operators control the water temperature difference within 10 degrees. If the cooling water temperature is lower than the room temperature by more than 10 degrees, dew condensation will occur, which will have a great impact on the laser energy and the service life of optical accessories. It is recommended to consult the specific parameters of the water cooler of the equipment manufacturer in advance, and then check. Reasonable control of room temperature and humidity can effectively avoid failures caused by moisture or condensation and high temperature.
3. High-power plate fiber laser cutting machine cuts thick plate metal, and the work will produce metal dust. The guide rail should be cleaned frequently to remove dust and other debris, and the bracket of the laser equipment must be wiped and lubricated frequently to ensure lubrication and no debris.
The high-power laser cutting machine is in a state of high temperature during the cutting process. Place the chiller in a ventilated place, and it is forbidden to pile up sundries on the air outlet above the chiller or around it. Remind laser operators to take proper rest and replenish water to avoid heat.
During the laser working process, if the machine makes abnormal sounds or other situations, the operation should be stopped immediately and the power should be turned off. When maintaining a high-power laser cutting machine, try to apply for the manufacturer’s online guidance or manufacturer’s maintenance.
Final reminder: The laser and water chiller should start up and run for half an hour before starting the cutting task. At this time, the water temperature and humidity have reached the set range.
Post time: Jul-25-2023
